|
Post by JohnH on Dec 19, 2013 10:19:50 GMT -5
Just a heads up for everyone..... I'm about to cut the radius bar for the lead truck, and noticed a small discrepancy in the article.. On page 44 of the current issue of LS&ORR it says that the radius bar is made from steel plate 3.2mm thick (1/8") but the drawing shows 2.3mm thick (.090) I'm going to use the 2.3mm figure, because the print clearly shows that the thinner section on the bottom is 2.3mm and the soldered on pieces on the top are shown as thicker and dimensioned as 3.2mm Maybe we can use this thread for all the other errors we find...? (hopefully no more) Thanks John
|
|